Cwfl-6000 Manual

This chiller features a phase sequence protector. If you turn on the power switch and the machine does not start (or shows a fault light), turn off the power and swap any two of the three live wires (L1, L2, L3) to correct the phase rotation.

Locate parameter (Low-Temperature Circuit Target): Adjust to your laser manufacturer's recommended setting (usually 25°C).

To extend the lifespan of your 6000W laser system, adhere strictly to this maintenance routine: cwfl-6000 manual

: Includes water level, over-temperature, and water flow alarms.

: Check the machine for any damage and verify that all accessories are present. This chiller features a phase sequence protector

: Upon first power-up, if you see error codes E08 or E09 , you need to adjust your 3-phase wiring connection order.

The CWFL-6000 utilizes an intelligent dual-channel temperature controller. By default, it is set to , meaning the water temperature automatically adjusts based on changes in the ambient room temperature. To extend the lifespan of your 6000W laser

Keep at least 50cm clear behind the air outlet and 30cm on the sides for proper ventilation.

Remember to always follow the manufacturer's instructions and guidelines for safe and efficient operation of the CWFL-6000 boiler.

The CWFL-6000 features color-coded, labeled inlets and outlets at the rear of the machine: