Troubleshooting CADWorx Error Number 6007: Causes and Solutions
I can provide specialized step-by-step instructions based on your specific workplace setup! HASP Support Guide - Green and Red Network Key - Intergraph
: This file forces the client to look at a specific server for its license. Locate the nethasp.ini file (usually found in the folder within your CADWorx installation). Verify that the [NH_TCPIP] section has the correct NH_SERVER_ADDR set to your license server's IP address. Update License Drivers error number 6007 cadworx
: Plugging in two local Intergraph/Hexagon hardware locks can cause conflicts, as CADWorx only reads from one. smartsupport1.intergraph.com Recommended Troubleshooting Steps Check Physical Connection
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. HASP Support Guide - Green and Red Network Key - Intergraph Verify that the [NH_TCPIP] section has the correct
For network licenses, verify the following:
Are you using a or a shared network license server ? This link or copies made by others cannot be deleted
In CADWorx, Error 6007 is a critical licensing issue that occurs when the software cannot detect or validate an authorized hardware lock (ESL). It is typically categorized alongside other 6000-series licensing errors. smartsupport1.intergraph.com Technical Overview
[NH_TCPIP] NH_SERVER_ADDR = 192.168.1.X ;; Replace with your actual license server IP address NH_TCPIP_METHOD = UDP or TCP NH_USE_BROADCAST = Disabled Use code with caution.