Everstart Battery Charger 60108m Manual Jun 2026

: High-speed charge for large batteries (e.g., marine or diesel). Special Features Battery Reconditioning

If the charger does not detect the battery (common with extremely low voltage), connect the charger to another 12-volt battery briefly, or use jump leads to connect a good battery to the dead one for a few minutes before starting the charger.

I can provide targeted troubleshooting steps to get your charger working again safely. Share public link

clamp to the negative (-) battery terminal or a metal part of the vehicle chassis away from the battery. everstart battery charger 60108m manual

Wind the cables neatly around the built-in cord wraps to prevent kinks and internal wire breakage.

If you need more specific advice, tell me you are trying to charge, how old your battery is , or what specific issue you are currently running into.

: Position the charger as far away from the battery as the DC cables permit. Never place the charger directly above the battery, as venting gases will cause corrosion. : High-speed charge for large batteries (e

Connect a 24-inch long, 6-gauge insulated battery extension cable to the negative post.

The EverStart 60108M is fully automatic. It will stop charging automatically when the battery reaches full charge.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Share public link clamp to the negative (-)

Connect the AC power cord only after making the battery clamp connections.

The charger will detect the battery and begin the cycle. The display will show the status.

When finished: