Input your desired setpoint on the controller. For longevity of both the mold and the temperature control unit, avoid massive temperature jumps. If heating up from room temperature, consider ramping the temperature in increments rather than demanding an immediate jump to 360°C. Safety Systems and Precautions
The mold icon on the display changes color: Green (within tolerance), Red (too hot), or Blue (too cold).
Set your target setpoint temperature and press the button. 4. Operational Guide & Controller Navigation wittmann tempro plus d 360 manual exclusive
Check electrical fuses and phases; Inspect pump impeller for debris. 7. Data Interface and Industry 4.0 Integration
±0.2∘Cplus or minus 0.2 raised to the composed with power C Input your desired setpoint on the controller
Standard rubber hoses will fail immediately at 360°C. You must use high-temperature, high-pressure flexible metal hoses (stainless steel corrugated hoses) or rigid piping rated for the maximum operating temperature and pressure of the system. Operational Guidelines and Start-Up Procedure
Position the unit on a flat, vibration-free concrete floor capable of supporting its operating weight. Safety Systems and Precautions The mold icon on
Isolate power and check the heater relays. Verify that cooling water is flowing freely through the return line.